P80 Slide Sticking - I have a slide drag issue but my trigger bar isn't getting hung up on the plunger. The hump in the trigger bar is catching on the chamber opening section of the slide and. In a pinch you can punch both all 4 of p80 pins out and literally pull the slide off the frame. There are no polymer rail sections that hold the slide to the frame, just the front and real rails which. If the p80 slide is working on your glock you can be pretty sure the problem is with your build. Take your barrel and slide off and drop the barrel in with no recoil spring. Does it fit easily into battery with the slide/ barrel hood flush. Iโve currently built a p80 g17 with both the frame and slide completed. However, iโm having some trouble getting the slide to go on correctly. When i attach the slide to the. A few weeks back i worked on my p80 17 and after putting on the new slide it seems to not want to go back anymore after a few test racks and wont move at all. Iโm having a problem racking my slide all the way back. The slide starts off normal then at a certain point it gets rough and hard, seems like the slide is angling down into the polymer80. I just finished assembling my first p80 g19. I checked the trigger reset, and it seemed fine. I went ahead to disassembly the slide first by pulling the trigger, depress the. Mine seemed to get hung up but if i put a little pressure on the rear of the slide it would fall the rest of the way. Problem fixed itself after a thorough oiling, racking and dry fire, then like 50rds,. I had similar issues, back plate rubbed and bound on the trigger housing when the slide went back (wouldnโt go back to battery and i had to strip to unstick it), and the slide and. I had a lower on which i could test my zaffiri zps. edc slide. When i pulled the slide all the way back, about half the time, it would stick there. The slide was getting hung up.
I have a slide drag issue but my trigger bar isn't getting hung up on the plunger. The hump in the trigger bar is catching on the chamber opening section of the slide and. In a pinch you can punch both all 4 of p80 pins out and literally pull the slide off the frame. There are no polymer rail sections that hold the slide to the frame, just the front and real rails which. If the p80 slide is working on your glock you can be pretty sure the problem is with your build.